This is just a library I made for fun.
This library has been made to easily interface and use the Nintendo Wii NunChuck with an Arduino or chipKit.
The library has not been tested in combination with the Wire library and I have no idea if they can share pins. Do not send me any questions about this. If you experience problems with pin-sharing you can move the NunChuck SDA and SCL pins to any available pins on your development board. This library will in this case fall back to a software-based, TWI-/I2C-like protocol which will require exclusive access to the pins used.
If you are using a chipKit Uno32 or uC32 and you want to use the hardware I2C interface you must remember to set the JP6 and JP8 jumpers to the I2C position (closest to the analog pins).
This library will default to I2C Fast Mode (400 KHz) when using the hardware I2C interface.